ModMyPi Grove Pi Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+ / 2 / 3 Grove...
MKR1000 Zebra Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Genuino MKR1000 7x Acrylic plates 4x M3 x...
Media Centre Setup Guide
If you've purchased our amazing Media Centre Kit, plugged it all in, powered it up, you might find it boots straight into the Raspbian operating system. Fear not, its super...
Matchbox Keyboard - Raspberry Pi Touchscreen Keyboard
So you’ve got a shiny new touchscreen for your raspberry pi but are a little miffed that you still need to plug a keyboard in to be able to type…...
Loading I2C, SPI and 1-Wire drivers on the Raspberry Pi under Raspbian "wheezy"
On many Raspberry Pi distributions, including Raspbian, the SPI and I2C device drivers are not loaded by default on boot. The file named '/etc/modprobe.d/raspi-blacklist.conf' indicates which kernel modules must not...
JustBOOM HAT Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 6x Red Acrylic Pieces 4x...
JustBOOM Zero pHAT Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi Zero 6x Red Acrylic Pieces 8x...
JustBOOM DAC + AMP Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 6x Red Acrylic Pieces 4x...
Itead GSM Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 Itead GSM Breakout Board 8x...
Naked USB Hub Case Assembly Instructions
Bill of materials: 4x 1/4" OD Hex Standoffs (Male-Female) / 4-40 x 3/4" 4x 1/4" OD Hex Standoffs (Male-Female) / 4-40 x 3/8" 4x 1/4" OD Hex Standoffs (Female-Female) / 4-40 x 1/4"...
Introduction to the Raspberry Pi
A Raspberry Pi can talk! No, really! What is this magic we speak of? Well, the Raspberry Pi is not in fact, a tasty, fruity, delicious pastry, but a fully...
Raspberry Pi Sense HAT tutorial
Installing and using your Raspberry Pi Sense HAT is easy, just follow our simple guide below to get started. Install Install the Sense HAT software by opening a Terminal window...