Skip to content
Raspberry Pi Plant Pot Moisture Sensor via Analogue Signals
Raspberry Pi Plant Pot Moisture Sensor via Analogue Signals Introduction Before we step into this tutorial, it’ll be good to have a small understanding of the difference between analogue and...
Raspberry Pi JAM HAT Case Assembly Guide
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi 3 B+ Raspberry Pi JAM HAT...
Raspberry Pi GPS HAT and Python
This tutorial assumes you are using an up-to-date Raspbian install, have access to either LXTerminal or SSH and have an internet connection! We're going to go through the steps on...
Raspberry Pi Camera Tutorial
Please note that this article is for pre-Bullseye operating systems which use the Raspicam stack (raspistill/raspivid) and not libcamera. Please visit this page for libcamera setup and usage. Setting up...
Raspberry Pi 7" Touch Sreen Display Case Assembly Instructions V2
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 Raspberry Pi Touch Screen Raspberry...
Nwazet Key Lime Pi - Reading Analog Inputs
Before you start, ensure that the SPI driver is loaded on your Raspberry Pi distribution. The following Python sample reads from a TMP36 analog temperature sensor every second. It converts the raw temperature data...
Raspberry Pi 7" Touch Sreen Display Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi A+/B+/2 Raspberry Pi 7" Touchscreen Display...
Nwazet Go Pro Kit Assembly Instructions
Assembly time: approximately 20 minutes. The nwazet Pro Kit is built around two black acrylic plates laser cut to receive the modules. The plate with only 3mm screw holes is...
Raspberry Pi 7" Touch Screen Assembly Guide
Before we assemble the touch screen, we need to make sure that our Raspberry Pi has the latest version of Raspberry Pi OS, and that all the software is up...
Raspberry Pi 3 Model A+ VESA Case Assembly Guide
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi 3 A+ Raspberry Pi 3 A+...
Nwazet Pi B+/2/3 Camera Box Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+ / 2 / 3 Raspberry...
Nwazet Pecan Pi Relay assembly and sample code
PCB Specifications Copper weight: 2oz Material: FR4 Board thickness: 2.3622mm (0.093") Bill of Materials PCB Designator Description Part # Quantity N/A Schrack Relay RZ03-1A4-D005 6 R1-6 Wire contacts Phoenix Contact...
