Skip to content
PiOT Relay B+/2/3 Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials ModMyPi PiOT Relay Board 7x Acrylic plates 3x...
PiOT Relay Board Handshake Confirmation
One of the features of our PiOT Relay Board is the ability to activate and deactivate it using a handshake pulse train. This is a neat little feature, however wouldn’t...
Pine64 2Gb Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Pine64 2Gb 9x Acrylic plates 4x M3 x...
Pi Monster Lighting Board Assembly
Bill of Materials 1x PCB 2x 10mm LED 4x Resistors 1x 10k ohm 1x 100 ohm 1x 10 ohm 1x 27 ohm 1x 2N7000 Transistor 1x 3x1 0.1” pin header...
Pi-Digi+ ModMyPi Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 IQaudIO Pi-Digi+ 6x Acrylic Pieces...
NOOBS - New Out Of Box Software
NOOBS is Raspberry Pi's New Out Of Box Software which makes installing your favourite OS easy! If you have purcahsed your SD card from us then NOOBS will be pre-installed....
Pi-DigiAMP+ ModMyPi Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 Pi-DigiAMP+ Full-HD Class D Amplifier...
Pi-DAC+ ModMyPi Case Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi A+/B+/2 Pi-DAC+ Full-HD Audio Card 6x...
PiCO UPS Reset Wire
PLEASE NOTE. THESE INSTRUCTIONS ARE FOR THE UPS PICO HV2.0 NOT THE NEWER RASPBERRY PI 3 VERSION UPS PICO HV3.0 - THE LATEST INSTRUCTIONS, FIRMWARE AND SCRIPTS ARE ALL AVAILABLE ON THE UPS PICO WIKI...
PIco UPS Cases - Tall - Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 PIco UPS 14x Black Acrylic...
PIco UPS Cases - Standard - Assembly Instructions
The laser-cut parts of the case are protected by an adhesive film which needs to be removed before assembly. Bill of Materials Raspberry Pi B+/2/3 PIco UPS 14x Black Acrylic...
PicoBorg - Basic Motor Set Up Guide
Introduction The PicoBorg is an ultra compact motor controller for the Raspberry Pi. With PicoBorg, you can turn on and off fans, motors, solenoids or relays from your Raspberry Pi....
