Waveshare PoE IO Board for Raspberry Pi CM5

This board is made exclusively for the Raspberry Pi Compute Module 5 (CM5) and comes with different features onboard such as a CM5 socket compatible with all CM5 variants, dual HDMI ports supporting 4K output, and dual MIPI interfaces for connecting DSI displays or CSI cameras.

It also comes with two USB 3.2 Gen1 ports and two USB 2.0 ports for all your USB connection needs. Networking is handled via the Gigabit Ethernet RJ45 connector with Power over Ethernet (PoE) support, allowing both data and power transmission over a single cable. An M.2 M-Key slot is available for NVMe SSDs and an SD card is located underneath the board for Lite CM5 variants.

There is also a 40-pin GPIO header for HATs, an RTC with a battery holder for timekeeping, and a fan connector to attach a fan. A 5V/5A USB Type-C port is onboard for traditional power options.

What's on Board

1. CM5 Socket
   Suitable for all variants of Compute Module 5
2. USB Type-C power supply/programming
   5V/5A power supply also allows burning system images into Compute Module 5 variants
3. M.2 Solid State Drive indicator
   Keeps blinking while reading/writing
4. M.2 M Key
   Compatible with 2280/2260/2242/2230 NVMe drives or AI accelerator module
5. Dual MIPI Interfaces
   For connecting DSI LCDs or CSI cameras
6. PSW Button
   Power button
7. 40-pin GPIO Header
   For connecting various HATs
8. RTC Battery Holder
   Supports CR2032/ML2032 button cell
9. HDMI Ports
   2x HDMI ports, supports dual 4K output
10. Status Indicators
    ACT: Raspberry Pi operating status indicator
    PWR: Raspberry Pi power indicator
11. USB 2.0 ports
    2x USB 2.0 ports, for connecting sorts of USB devices
12. USB 3.2 Gen1 Ports
    2x USB 3.2 Gen1 high-speed ports, supports 5Gbps synchronous operation
13. Gigabit Ethernet Connector
    Gigabit Ethernet RJ45 with PoE support
14. FAN Connector
    For connecting the cooling fan
15. Misc Configurations
    For extending other functions
16. IO-VREF/PoE Selection
    CM5 IO logic level: 3.3V or 1.8V
    PoE: enable (EN) or disable (DIS)
17. CAM1 and DISP1 I2C Bus
    Fit the jumpers when using CAM1 or DISP1
18. SD Card Slot (bottom side)
    Insert a SD card with a pre-burnt system, to start up Compute Module 5 Lite

Connection Example - CM5 & 40-pin GPIO

Note: Compute Module 5 and Adapter are NOT included

Specifications

Resources

• Product Wiki
• CM5 Core Board Datasheet

Package Contents

• 1x Compute Module 5 PoE Board
• 1x Screws pack