This USB-C CDC Serial Adaptor from 8086 plugs directly into the dedicated UART port on the Raspberry Pi 5 (using the supplied JST cable) providing quick serial console access via a USB-C cable (not included).
The adapter uses a 3-pin JST-SH connector and comes with a 10cm cable (compatible with 1mm pitch JST-SH) - we stock more sizes of JST-SH to JST-SH cable here. 3-pin cables for the Raspberry Pi Debug Probe can also be used.
The Serial console is enabled by default on Raspberry Pi OS (Bookworm) elsewhere it can normally be enabled by adding enable_uart=1 to the config.txt file in the boot partition. The IC is used in the adapter enumerates as a Communication Device Class (CDC) device which modern (Win10/Linux/Mac OS X) operating systems have built in drivers for.
When using with a Raspberry Pi 5 in an official case the cable can exit in the gap at the side of the Ethernet port.
This board can only be used with systems using 3.3V, connecting to those using higher/lower voltages may result in damage.
Pinout
Pinout
Description
TX
Transmit (connect to remote RX)
GND
Ground
RX
Receive (connect to remote TX)
Baud Rates
The following baud rates are supported:
Baud rate
Miss rate (%)
2400
0.16
4800
0.16
9600
0.04
19200
0.04
38400
0.16
57600
0.16
115200
0.16
230400
0.16
460800
0.79
1700000
0.84
2300000
0.62
3400000
0.84
Package Contents
1x USB-C CDC Serial SH board
1x 10cm JST-SH cable
Raspberry Pi 5 and case not included
Payment & Accreditations
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Skip to content
