This 100mm Grove to Bare Wire Cable provides a simple way to connect Grove boards and breakouts to custom wiring, with four colour-coded bare wires for power, ground and signals.
If you'd like to make a connection to a board or breakout with Seeed Grove connection, this 100mm long 4-wire cable is fitted with a Grove connector and four bare wires.
Please note: You will have to watch for voltages on the power/signal pin when using 3V-only sensors, because Grove boards that are 5V logic like many Arduino UNO-compatibles.
The colours are:
Black for GND
Red for V+ - Can be 3V or 5V power depending on the microcontroller board!
Blue for SDA
Yellow for SCL
Note these are not JST cables, and won't fit in JST PH sockets!
Features
100mm long 4-wire Grove connector cable
One end fitted with Grove connector, opposite end with four bare wires
Colour-coded wires: Black (GND), Red (V+), Blue (SDA), Yellow (SCL)
Compatible with Grove boards and breakouts
Supports 3V or 5V power depending on microcontroller board
Voltage compatibility check required for 3V-only sensors with 5V logic boards
