Troubleshooting a Raspberry Pi HDMI/VGA Adapter

Troubleshooting a Raspberry Pi HDMI/VGA Adapter

While your monitor should be able to communicate its' abilities to your Raspberry Pi, there are times that the 'standard' that an old monitor uses is not recognised by the Raspberry Pi. This is especially true with old VGA monitors for which you need to use an HDMI/VGA adaptor like the one available from The Pi Hut.  The Raspberry Pi tries its best, but sometimes you have to intervene and make some manual changes.

Of course, if your Raspberry Pi is not displaying the image correctly, how are you going to make those changes. Fortunately, the boot partition on your SD card (assuming you are using Raspbian, and not NOOBS) is readable on a PC or Mac. On that partition is a file called config.txt which sets up your Raspberry Pi as it boots.

First, try uncommenting the following line by removing the # from the start:

This line tells the Raspberry Pi to force output through the HDMI port, and not the composite port (the yellow plug on the original Raspberry Pi, or shared 3.5mm audio/video port on the A+/B+/Pi2). Save the file, eject it from your PC/Mac, put it back into your Raspberry Pi and try booting again.

If this does not work, try uncommenting the following line:


This will boost the HDMI signal. The value ranges from 0 (the default) to 7 (maximum). Try increasing it if necessary.

The last value you may try to uncomment is:


If one of these three works, you may find that your Raspberry Pi is not using the monitor's optimal screen resolution. If this is the case then you may have to manually tell the Raspberry Pi to use a specific resolution.

Once again, edit the config.txt file and add the following four lines:


The first line tells the Raspberry Pi to ignore everything that the monitor is telling it about the resolution it can run at.

The second line tells the Raspberry Pi to output video and sound through the HDMI port. Most VGA adaptors have an audio out for connection to your monitor or external speaker.

The next line tells the Raspberry Pi to use a resolution defined in the 'DMT' group of resolutions supported by most monitors.

The last line tells the Raspberry Pi which resolution to use. Mode 28 is for 1280x800. The following lists some of the most common resolutions: 

Mode Resolution Frequency notes
4 640x480 60Hz
9 800x600 60Hz
16 1024x768 60Hz
21 1152x864 75Hz
23 1280x768 60Hz
28 1280x800 60Hz
32 1280x960 60Hz
35 1280x1024 60Hz
39 1360x768 60Hz
42 1400x1050 60Hz
47 1440x900 60Hz
51 1600x1200 60Hz
58 1680x1050 60Hz
69 1920x1200 60Hz
81 1366x768 60Hz
82 1920x1080 60Hz 1080p
85 1280x720 60Hz 720p

There are a lot of other resolutions available if yours is not listed above. A full list is available on the Raspberry Pi website documentation area.

Hopefully you now have a working VGA monitor!

Featured Products

The Pi HutRaspberry Pi 3 HDMI to VGA Converter
Sale price £8 incl. VAT excl. VAT

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.