For all models of Raspberry Pi Zero (ideally with a GPIO header installed), the Zebra Zero Plus Breadboard case provides the ultimate protection and prototyping convenience.
The most standout feature of the Zebra Zero Plus is the built-in breadboard for prototyping your next project - your Zero and prototyping area are right next to each other, making rigging up components with the GPIO and jumper wires super simple!
The clear top and wood bottom provides a clear view of the board while maintaining a low profile, thanks to the C4 nuts. A benefit of these nuts is that they can accept a bolt from either end. So if you install a HAT or pHAT, it can be secured to the nuts on the other side.
A straight or angled GPIO header can be installed on either side of the board. We have also designed this new model to fit a full GPIO cable connector from either side.
Available in the following colours:
- Clear top and wood bottom with wood accents
- 8x30 Pin Breadboard with 4 power rails
- 2 wood spacers
- 4 Stainless Steel Nuts & Screws