UPS PIco - JST-XHP-2 Battery Connector (2 Wire)

The UPS PIco features a female XHP-2 connector on board for LiPo battery connections. These JST-XHP-2 cable assembles will allow you to connect 3rd party LiPo's to our UPS PIco!

They're 70mm long, feature a 22AWG core on each wire, so plenty thick for most battery loads (max. 8A), and terminate in a male JST XHP-2 on both ends.

We do not offer warranty on PIco's broken due to the use of a 3rd party batteries disregarding the notes below

Important Notes when using 3rd Party LiPo's with the UPS PIco

• Check the positive & negative terminals of the LiPo are correct - They are not all the same!
• LiPo Charging Voltage must be 4.2 V
• C factor should allow battery to provide more than 6A
  • e.g. 450mA x 15 (C factor) = 6.75A or 3000 mAh x 2 (C factor) = 6A
• Larger batteries must have PCM protection installed on battery

Features

• 2 Pin JST-XHP-2 Assembly (Red/Black)
• Current rating: 8A AC, DC (AWG #22)
• Voltage rating: 100V AC, DC
• 70mm Long
• Temperature range: -25?C to +85?C (including temperature rise in applying electrical current)
• Contact resistance: Initial value/10m ? max. After environmental testing/20m ? max.
• Insulation resistance: 1,000M ? min.
• Withstanding voltage: 800V AC/minute

Downloads

Datasheet