If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The Lithium Battery Charger can charge 3.7V LiPo battery at a rate of 500mA per hour. It is designed to charge single-cell Li-Ion or Li-Polymer batteries. Check the datasheet below to see if it will work with your battery.
The board incorporates a charging circuit, status LED, connector for your battery (JST-type used in the batteries we carry), and a micro-USB connector. Four small mounting holes allows this charger to be easily embedded into a project.
Project 1. Light of Earth - A BMI160 gyroscope accelerometer based 3D Printing LampA light can be turned on by knocking on the table.
Material Lists:
- Gravity: I2C BMI160 6-Axis Inertial Motion Sensor
- Beetle - The Smallest Arduino
- 3.7v lithium battery charger
- 3.7v lithium battery
- 10 piranha lamp beads
- A small amount of acrylic pigment (green, yellow, blue and brown; if gray and white pigment is provided, the oil paint does not need to be prepared)
- Light gray and white oil paint
- A good-looking 2-foot button (I bought it on Taobao)
- Lead wire (2 mm) (If no, replace it with soft iron wire)
- 40 cm PVC hollow rod (I use the one with outer diameter 9 mm and inner diameter 5 mm)
- A screw and nut with the length of 20mm
Project 2. How To Make A Smart Clock with ESP32?
I’ve always been dreaming of making a desktop clock which without complex functions, just smaller and can display time.
Hardware:
- Gravity I2C OLED-2864 Display
- Gravity: I2C Triple Axis Accelerometer
- Beetle BLE - The smallest Arduino bluetooth
- 3.7v lithium battery charger
- 3.7V Polymer Lithium Ion Battery - 1000mA
- Shell (3D printing)
- Black Acrylic Transparent Board
Project 3. A Christmas present for cute kid & girl - A Clever Rabbit Hat - an EMG sensor basedThings you may need in this project:
-
Gravity: Analog EMG Sensor by OYMotion ×1
-
Beetle - The Smallest Arduino ×1
- 3.7v lithium battery charger ×1
- 3.7 V Lithium Battery ×1
-
9g 180° Micro Servo ×2
- Rabbit Hat ×1
- Needles and Thread
- Two-step Toggle Switch ×1
- Elastic (Width: 1.5cm Length: 40cm) ×1
- Stick ×2
- Hot Melt Adhesive
Project 4. Halloween pumpkin lamp made by micro:bit
How can a Halloween without a pumpkin lamp? The pumpkin lamp made of recently popular Microbit is a good choice.