L76X Multi-GNSS Module (GPS, BDS, QZSS) [discontinued]

This is a general GNSS module which supports Multi-GNSS systems: GPS, BDS, and QZSS, with advantages such as fast positioning, high accuracy, low power consumption, etc.

This module is great for use in microcontroller-based projects as well as with the popular SBCs on the market today and would be perfect in your next Raspberry Pi, Arduino, or Adafruit Feather HUZZAH project. 

Online development resources are available, which include wiring guidance and example code, with additional information being found on the Product Wiki & Manual.

Features

• Supports Multi-GNSS systems: GPS, BDS, and QZSS
• EASY™, self track prediction technology, help quick positioning
• AlwaysLocate™, intelligent controller of periodic mode for power saving
• Supports DGPS, SBAS (WAAS/EGNOS/MSAS/GAGAN)
• UART communication baudrate: 4800~115200bps (9600bps by default)
• Onboard rechargeable Li battery MS621FE, for preserving ephemeris information and hot starts
• 2x LEDs for indicating the module working status
• Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

• Communication interface: UART
• Baudrate: 4800~115200bps (9600bps by default)
• Update rate: 1Hz (default), 10Hz (max)
• Protocols: NMEA 0183, PMTK
• Power supply voltage: 5V / 3.3V
• Operating current: 11mA
• Operating temperature: -40℃ ~ 85℃
• Dimensions: 32.5mm x 25.5mm

GNSS Specifications

• Band: GPS L1(1575.42Mhz), BD2 B1 (1561.098MHz)
  • Channels: 33 tracking ch, 99 acquisition ch, 210 PRN ch
  • C/A code
  • SBA: WAAS, EGNOS, MSAS, GAGAN
• Horizontal position accuracy:
• Autonomous: <2.5mCEP
• Time-To-First-Fix @-130dBm (EASY™ enabled):
• Cold starts: <15s
• Warm starts: <5s
• Hot starts: <1s
• Sensitivity:
• Acquisition: -148dBm
• Tracking: -163dBm
• Re-acquisition: -160dBm
• Dynamic performance:
• Altitude (max): 18000m
• Velocity (max): 515m/s
• Acceleration (max): 4G

Whats On Board

1. L76B module
2. RT9193-33:  power manager
3. Rechargeable MS621FE Li battery:  for preserving ephemeris information and hot starts
4. Ceramics active antenna
5. GPS status indicator
6. Power indicator
7. PH2.0 5PIN connector
8. GNSS antenna connector
9. Backup mode wakeup jumper:  not soldered by default, short the jumper to exit backup mode

Resources

• Product Wiki & Manual

Pinout

1. VCC - Power supply (3.3V/5V input)
2. GND - Ground
3. TX - Connect to MCU.RX (signal direction: TX >> MCU.RX)
4. RX - Connect to MCU.TX (signal direction: MCU.TX >> RX)
5. PPS - GPS status indicator

Package Contents

• 1x -L76X GPS Module
• 1x - PH2.0 5PIN wire