The Docker Pi IoT Node (A) adds GPS/BDS (Beidou), GSM and LoRa to your Raspberry Pi !
The board communicates to the Raspberry Pi over I2C to control LoRa & GSM connectivity as well as the GPS/BDS module through the SC16IS752 chip.
For LoRa, the board uses an AI-Thinker RA-01 module which supports 410MHz - 525MHz bands.
The unit can also be controlled directly without programming and the Raspberry Pi's GPIO pins are extended to allow stacking if required.
The unit comes complete with two antennas for long-range sensor applications and a high-gain built-in ceramic active antenna for GNSS.
Note : Raspberry Pi not included.
Features
Programmable
Control directly (without programming)
GPIO Pins extended for stacking
GPS/BDS Support
GSM Support
Lora Support
Can Stack with other boards
Independent of mainboard hardware (requires I2C support)
Supports 410MHz - 525MHz LoRa bands
Specifications
GPRS
Low power consumption, standby sleep current <1mA
Support GSM/GPRS four frequency bands, including 850, 900, 1800, 1900MHZ
GPRS Class 10
Support GPRS data service, maximum data rate, download 85.6Kbps, upload 42.8Kbps
Support standard GSM07.07, 07.05 AT commands, and access the serial port through I2C interface conversion
AT commands support standard AT and TCP/IP command ports
GPS
Support BDS/GPS joint positioning
Support A-GPS, A-BDS
Support standard SIM card
LoRa
Transmission distance:500 Meters (RF parameters: 0x50 @ China City)
Support FSK, GFSK, MSK, GMSK, LoRaTM and OOK modulation methods
Ultra-high receiver sensitivity as low as -141 dBm
Support preamble detection
Packet engine with CRC, up to 256 bytes
LORA transceiver indicator
Easy TX/RX by Docker Pi
AI-Thinker RA-01 module - supports 410MHz - 525MHz bands
Package Contents
1 x IoT Node(A) Board
1 x Instructions
4 x M2.5*12 + 6 standoffs
4 x M2.5*6 Nut
4 x M2.5*6 Half-round head screw
1 x 433MHz L-Shaped Tape Antenna
1 x 2.4GHz PCB Antenna
1 x GPS/BDS High Gain GPS Built-in Ceramic Active Antenna
Resources
View more
View less
Skip to content
