ESP32-S2-DevKitM-1 Development Board

EspressifSKU: DFR0813
Price:
Sale price £17.10
incl. VAT
excl. VAT
Stock:
Only 8 units left
Quantity:

Awesome Extras

USB-A to Micro-USB Cable - The Pi Hut
The Pi HutUSB-A to Micro-USB Cable
Sale priceFrom £1.50 incl. VAT excl. VAT
Full-Size Breadboard - Transparent - The Pi HutFull-Size Breadboard - Transparent - The Pi Hut
The Pi HutFull-Size Breadboard - Transparent
Sale price £5 incl. VAT excl. VAT
The Pi Hut Jumper Bumper Pack (120pcs Dupont Wire) - The Pi HutThe Pi Hut Jumper Bumper Pack (120pcs Dupont Wire) - The Pi Hut

The ESP32-S2-DevKitM-1 from Espressif is an entry-level development board equipped with ESP32-S2-MINI-1 module.

Most of the I/O pins on the module are broken out to the pin headers on both sides for easy interfacing. Developers can either connect peripherals with jumper wires or mount the development board on a breadboard.

ESP32-S2-MINI-1 is a generic Wi-Fi MCU module that integrates ESP32-S2FH4 chip. ESP32-S2-MINI-1 comes with a PCB antenna and features a 4 MB SPI flash.

Board Features

ESP32-S2-DevKitM-1 Development Board Features

Key Component

Description

ESP32-S2-MINI-1

ESP32-S2-MINI-1 is a generic Wi-Fi MCU module that integrates ESP32-S2FH4 chip. ESP32-S2-MINI-1 comes with a PCB antenna. And the module features a 4 MB SPI flash.

3.3 V Power On LED

Turns on when the USB power is connected to the board.

USB to UART Bridge

Single USB-UART bridge chip provides transfer rates up to 3 Mbps.

I/O Connector

All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board. Users can program ESP32-S2FH4 chip to enable multiple functions such as SPI, I2S, UART, 12C, touch sensors, PWM etc. For details, please check the table below.

Reset Button

Reset Button

Micro-USB Port

USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-S2FH4 chip.

Boot Button

Download button. Holding down Boot and then pressing Reset initiates firmware Download mode for downloading firmware through the serial port.

RGB LED

Addressable RGB LED (WS2812), driven by GPIO18.

5V to 3.3V LDO

Power regulator that converts a 5 V supply into a 3.3 V output.

Specification

  • ESP32-S2FH4 chip, Xtensa single-core 32-bit LX7 microprocessor
  • 128 KB ROM
  • 320 KB SRAM
  • 16 KB RTC SRAM
  • 40 MHz crystal oscillator
  • 4 MB SPI flash
  • Operating Voltage/Power supply: 3.0~3.6 V
  • Operating Temperature Range: –40~85°C

Documents

Shipping List

  • 1x ESP32-S2-DevKitM-1 Demo Board

Payment & Accreditations

Payment methods
Visa Mastercard Maestro PayPal Amazon Klarna

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

Accreditations