The original motor driver board used by thousands of makers across the globe! The famous L298N has become the default starting point for new makers learning robotics thanks to its simplicity, robustness and low cost.
Maximum current output is up to 2A(peak) per motor. The board includes built-in flyback/back EMF diodes for added protection.
If you apply power greater than 20V and enable the on board 5V regulator, the board and components will get quite warm (but this is normal).
Motor compatibility
DC brushed motor with two terminals
Operating voltage: 7V to 30VDC
Rated current is <= 1.0 Amps
Peak current is <= 2.0 Amps
Or a Stepper Motor with 4 leads (bipolar)
Features
Dual Channel Motor driver for DC brushed motor
It can also drive bipolar stepper motor
1A continuous current per channel (2A peak)
Vmotor: 7V to 30VDC
Dimension: 5.5cm x 4.4cm 2.7cm
Ready with:
Vmotor, GND and 5V terminals
Output A and B terminals for motor
Heatsink mounted with L298 for better heat dissipation
Flyback EMF diodes
Header pins for IN1, IN2, IN3, and IN4
On board 5V voltage regulator
Compatible with Arduino, Raspberry Pi etc but will require manual wiring
Skip to content
