Not compatible with the new Raspberry Pi Touch Display 2!
The SmartiPi Touch Pro is a case for the (original) Official Raspberry Pi display and Raspberry Pi, with either a small back (25mm clearance above the Pi) or a large back (45mm clearance above the Pi).
This case creates an all-in-one Raspberry Pi computer with a single USB-C port or Micro USB port in the back to power the components within the case. The Raspberry Pi is mounted behind the display and the ports are flush with the edge. An included port blocking part allows you to only allow access to the ports that you want to be exposed.
A cooling fan is included to keep everything at the ideal operating temperature, which is fitted with the included rubber anti-vibration mounts to minimise fan noise.
A mounting point has been included below the display for the Official Raspberry Pi camera V1, V2 or the new Camera Module 3 (not compatible with the Raspberry Pi HQ camera). The camera hole can be completely hidden with the included adhesive panel.
There is also a second set of threaded inserts to mount your own development board or another piece of hardware. Perfect for an industrial or commercial application where you want to add your own development board to the case.
The case is made out of injection-moulded ABS plastic, so it can be drilled or machined for additional customization (invalidates warranty!).
Update! Now compatible with the Raspberry Pi 5** thanks to the new included cable, and still supports the Pi 4, 3B+, 3 and 2! Not compatible with the new Raspberry Pi Touch Display 2!
Notes
Raspberry Pi display, Raspberry Pi, and Raspberry Pi camera are not included
**The cables in this case only support up to 5V 3A (USB current will be limited with Pi 5)
Once assembled, the SD card, HDMI port, and audio jack are not accessible from outside the case. You can plug in an HDMI or audio cable into the Raspberry Pi inside the case and then run the wire outside the case
Two sizes are available - Small and large (select above before adding to basket)
Features
Works with the Official Raspberry Pi Display only
Not compatible with the new Raspberry Pi Touch Display 2!
Works with all variants of Raspberry Pi 5, 4, 3 and 2
Included cooling fan with rubber vibration mounts (Small panel to cover fan hole if not using the fan)
Two positions to mount the Raspberry Pi inside the case
Micro USB splitter for use with Pi 2 and 3 (Micro USB input)
USB-C Splitter for use with Pi 5/4 (USB-C input) - 3A max current
Metal base plate included
Back access panel for wire routing
Optional Raspberry Pi camera V1/V2/V3 mount included (not compatible with the Raspberry Pi HQ camera)
Camera hole can be hidden with the included adhesive front panel
Included port blocking part (cut out plastic knockouts with a knife - be careful!)
Two small foot mounts (included) can be used instead of the large stand
Display can pivot down to 37 degrees off of the surface
A second set of threaded m2.5 mounting points can be used to mount your own development board (HAT-compatible mounting points )
Skip to content
