Cart 0

Superfast Shippingfrom just £2.99

No Quibblereturns policy

Next Day Deliveryorder by 2PM*

Nwazet Pi Infrared Receiver

Nwazet Pi Infrared Receiver
Only 2 left!
£ 11.99

This little board plugs right into the Raspberry Pi's GPIO connector and decodes infrared signals sent to it from just about any generic IR remote control. This IR receiver is tuned for a 38kHz carrier frequency but it will accept IR frequencies slightly above or below that at the cost of a reduced range. The IR stream is fed to the Raspberry Pi on GPIO #18, which is the default pin used by the Raspberry Pi's LIRC GPIO driver.

Features:

  • IR decoder: Vishay TSOP75238W
  • Carrier Frequency: 38KHz
  • Transmission Distance: 30m (98.4 feet)
  • Output Current: 5 mA
  • Operating Voltage: 2.5V to 5.5V (3.3V on the Raspberry Pi)
  • Supply Current: 0.35 mA
  • Power Dissipation: 10 mW
  • Maximum Operating Temperature: +85 Celsius
  • Minimum Operating Temperature: -25 Celsius
  • Beam Angle: 75 degrees
  • 0.1" pin header friendly for hacking the Raspberry Pi's GPIO connector

Tutorials

IR Decoder: Vishay TSOP75238W

Linux IR Remote Control

Raspberry Pi LIRC Driver